-
Content count
9 -
Joined
-
Last visited
Community Reputation
0 NeutralAbout Mahmoud Abd El-Hameed
-
Rank
Newbie
- Birthday 08/10/86
Profile Information
- Gender Male
- Location SAUDI ARABIA
- Country Egypt
- Interests AUTOMATION ENGINEER
-
Mahmoud Abd El-Hameed started following 3G2C7-LK201 and RS232 comm with LSS (and SCADA)
-
URGENT I have omron servo motor connected to mcw 151 motion card, it is working OK . card is damaged so we change with new-card, we upload program from old card , check in other machine program is OK , we get the new card , install it ( not working .. download program to new drive ... not working also , try on other machine , not working ..) we remove old card from other machine try at stopped machine it worked OK. also delete old program from working card an re-download to it again .. working OK. so we decide to change the motion card with new one >> but some one change the parameter of the servo so if i get new card what parameters i should set to work with motion-card and also if i only download the program to new card machine will work or some data must be set in first. regards
-
I NEED TEST SOFTWARE ON PC TO CHECK MODEBUS RTU COMMUNICATION WITH SLAVE PLC ( CJ1 ). ALSO CABLE OF PLC TO CONNECT WITH SOFTWARE.
-
Actualy i didnt make any modification just upload and dwonload. is that enough thankyou
-
I GET OTHER PROBLEM, i had an old mcw151-e card working good. i get new card as a spare. When i remove old one and replaced by new one. I DID THIS STEPS: 1- UPLOAD OLD PROGRAM. 2- install new one. 3- Dwonload old program in new device. But not working at all mo errors, no alarms , but not working I removed it and but in other working drive and try, same situation. HELP ME :((((
-
NEED COMMUNICATION CABLE WITH PIN arrangment for MCW151-E and laptop ( have serial to usp connection ).
-
urgent matter
Mahmoud Abd El-Hameed replied to Mahmoud Abd El-Hameed's topic in Other Omron Software
i see the communication for serial port then connecting +5vdc and GND for the pins must be connected with. that mean i connect the serial only with pins of power supply. -
urgent matter
Mahmoud Abd El-Hameed replied to Mahmoud Abd El-Hameed's topic in Other Omron Software
THANKS ALLOT TO YOUR EFFORTS I WANT TO KNEW IF NT-XS WORKING ON WINXP OR NOT. ALSO IF I COULD UPLOAD OR DOWN LOAD IN THIS HMI WITHOUT CONNECTING TO PLC. I GAVE IT SUPPLY AND IT'S ON .. EXTERNAL POWER SUPPLY -
dear all i have a NT2S-SF126B-E OMRON HMI I NEED THE PROGRAMMING CABLE DIAGRAM OR HOW TO CONNECT WITH PC AND ALSO HOW TO CONNECT TO PLC I HAVE NT-SHELL SOFTWARE BUT NO DATA ABOUT COMMUNICATION WITH THIS TYPE OF HMI THANKS
-
hii all I need your help in cx-opc server is it connecting between CXS and other plcs not from omron like mitsubishi or semiens and hoe coul i do this. regards, Mahmoud Automation engineer Mahmoud@cesco-omron.com