Kenan

MrPLC Member
 View profile  See their activity

  • Content count

    3

  • Joined

  • Last visited

Posts posted by Kenan

  2. Posted

    Hi,

    Thank you for your help. Machine designer sent me some values. I attached.

    I downloaded configuration software.

    Now, when I this, do I disconnect cable HMI? Or keep HMI in manual mode, and plug-in my laptop?

    Screenshot_20221104-181033_Chrome.jpg

    Screenshot_20221104-162507_Email.jpg

  3. Posted

    Hi,

    I have a servo coil feeder. It has HMI, PLC, MR-JE-100A Servo drive, and motor. 

    Recently,  smoke came out of drive.

    One capacitor was almost split. 400 V, 680 uF. This is right after 3-P rectifier. I believe there was some sort of over voltage.

    I found the capacitor from China,  and installed. HMI and PLC are sending power and signals, but no sign of activity at the drive. DC bus is alive, but can't pass beyond relay after bridge rectifier. There is no power at control circuit either.

    No service manual.

    I ordered another same drive.

    Do I need to set anything on the drive, or HMI and PLC has all the necessary signal to drive the motor?

    NC+servo+Roll+Feeder+manual (2).pdf