Kenan

MrPLC Member
  • Content count

    3
  • Joined

  • Last visited

Community Reputation

0 Neutral

About Kenan

  • Rank
    Hi, I am New!

Profile Information

  • Country United States
  1. Servo drive control power

    Sorry, first attachment got in here by accident.
  2. Servo drive control power

    Hi, Thank you for your help. Machine designer sent me some values. I attached. I downloaded configuration software. Now, when I this, do I disconnect cable HMI? Or keep HMI in manual mode, and plug-in my laptop?
  3. Servo drive control power

    Hi, I have a servo coil feeder. It has HMI, PLC, MR-JE-100A Servo drive, and motor.  Recently,  smoke came out of drive. One capacitor was almost split. 400 V, 680 uF. This is right after 3-P rectifier. I believe there was some sort of over voltage. I found the capacitor from China,  and installed. HMI and PLC are sending power and signals, but no sign of activity at the drive. DC bus is alive, but can't pass beyond relay after bridge rectifier. There is no power at control circuit either. No service manual. I ordered another same drive. Do I need to set anything on the drive, or HMI and PLC has all the necessary signal to drive the motor? NC+servo+Roll+Feeder+manual (2).pdf