MrPLC Member
  • Content count

  • Joined

  • Last visited

Community Reputation

0 Neutral

About Just_Inquiring

  • Rank
    Hi, I am New!

Profile Information

  • Country Canada
  1. Micrologix 1000 Fault Problem

    Dear wizard. Thank you for your reply.  However, I'm still lost, How does one physically perform an "F10" on that PLC,  Micrologix 1000 I see no means of interface other than the round pin connector, no buttons, ?? The device is not networked. Is there something I need to toggle or shunt etc? See image Below. I have a programming cable  and was able to obtain RSLinx_classic software. Is there another method to perform an F10 without software and cable?   Is any other software required?     Regards.  
  2. Would someone be so kind as to document a method to clear a fault on a Micrologix 1000. Does one need programming cable and software or is there another method to clear a fault to see if it returns? regards.