Brad

They seem to be the same.

Just used the counters because they are already in the program.

Wrote a formula to count or try to count past the number 32767. Trying to keep track of cycles between rebuilds. Attached a copy of the formula, will this work. Or is there a better way?

Easy is better. Thank-you all for your time and the help!

Yes.

You are right I am confused sorry. I am trying to multiply, N80:0 through N80:6 by 2 at one time. using a Micrologix 1500

TWControls, I am trying to do what you wrote. I have copyed a word N15:0 through N15:6 and move it to N80:0 through N80:6 I need to multiply in one scan.

TWControls, Yes that is what I am trying to do. If I just use the MUL it only multiplys one bit!

I am using a CPW comand to move a word to another file were I need to multiply the word, (or would like to) instead of each bit in the word. can this be done?

I want to use two Operator Interface Panels to communicate with a Micrologix 1500 from different locations. The panels that I have can be hooked up to communicate via a DH-485 network. Can I bridge between a DH-485 and my existing Ethernet Network?

WHAT ARE THE PRO'S AND CON'S WITH USING AN EPROM MEMORY MODULE?

I want to have a clock that will reset each time a bit goes true. Trying to keep track of the last time a change is made. I have a timer set up to set off an alarm when the same change is not made. To make a long story short, I am looking for a way to have a clock give me a time in between the changes. Once I have that I can transfer that information to a monitor or spread sheet.

got it! It was in the snytax!! Thank-you!!

To clarify I have a network computer running rslinx gateway A network computer running excel Iam not having a problem reading data using dde but Iam not able to do ddepoke thru excel only reads.

How do I poke a DDE link through Linx Gateway using a remote PC with Excel.