GreyWolf

MrPLC Member
 View profile  See their activity

  • Content count

    13

  • Joined

  • Last visited

Posts posted by GreyWolf

  2. Posted

    Hi , A simple advice : in your future activity first of all read careful the user's manuals. You'll find a lot of useful things. Your project may look like this : ( NC/I0 )---------( NC/I1 )--------(M0) (NO/M0)---------------------------------(T0) (NO/T0)----------------------------(Q0) Where I0 = Tank level probe I1 = Motor protection M0 = Intermediate relay T0 =Delay timer ( on delay/15 sec. ) Q0 = Output / Start - Stop motor NC = normaly closed contact NO = normaly open contact Best regards

  4. Posted · Edited by GreyWolf

    Hi, I'm not a specialist in PLC programming but I'll be glad if I could help you. The ALM/ERR indicator on the front side of plc is light on ? If not,you have to connect a Programming Console to PLC and follow the instructions given in the Operation Manual,section 10-Troubleshooting.

  7. Posted · Edited by GreyWolf

    Could someone to tell me how to convert a 0 to 10V analog signal input into two digital outputs used for changing the revolution sense of a 3 phase AC motor ( by means of 2 interlocked contactors)? I have a CPM1A-30CDR-A unit a MAD01 analog I/O unit and a current to voltage transducer (0-100A to 0-10V). Many thanks in advance

  10. Posted

    Hi , Paw Right now I have in my hands the "Fuji general-purpose inverter FVR-E9S-EN Series" instruction manual but I have no possibility to send it to you,so I've tried to find it out on Internet . NO CHANCE ! HOW COULD THIS BE POSSIBLE? I found something for you and I hope to be useful .It is an instruction manual for FVR-E11S Series. Regards MEH404a.pdf

  13. Posted

    Hello Paw, Can you post here the model of your Fuji inverter? You can see the model on the label attached on it. Regards