Kdawg

MrPLC Member
 View profile  See their activity

  • Content count

    10

  • Joined

  • Last visited

Posts posted by Kdawg

  4. Posted

    I’m trying to put in some rungs which will trigger alarms for each of those points. In the manual it states in registers SD 207-SD209? That’s only 3. For 11 different alarms. The manual says it goes by priority but does say when it triggers were it resides. My local rep suggested SD0. But again it’s only one. Would like 11 inputs to trigger 11 (M3000). Can u suggest something? Your help is greatly appreciated 

  5. Posted

    Im trying to create some rungs to monitor some PLC Faults.  AC Down, I/O Module Fuse, Op Error, PRG time over, Low Battery, Clock Data, StBy Mode, Annuuciators, LED Instructions. However, I cant figure out what logic to use in order to display these faults as the Addressing is limited. Can anyone help? 

  6. Posted

    Im trying to create some rungs to monitor some PLC Faults.  AC Down, I/O Module Fuse, Op Error, PRG time over, Low Battery, Clock Data, StBy Mode, Annuuciators, LED Instructions. However, I cant figure out what logic to use in order to display these faults as the Addressing is limited. Can anyone help? 

  7. Posted

    Im trying to create some rungs to monitor some PLC Faults.  AC Down, I/O Module Fuse, Op Error, PRG time over, Low Battery, Clock Data, StBy Mode, Annuuciators, LED Instructions. However, I cant figure out what logic to use in order to display these faults as the Addressing is limited. Can anyone help? 

  8. Posted

    Im trying to create some rungs to monitor some PLC Faults.  AC Down, I/O Module Fuse, Op Error, PRG time over, Low Battery, Clock Data, StBy Mode, Annuuciators, LED Instructions. However, I cant figure out what logic to use in order to display these faults as the Addressing is limited. Can anyone help? 

  9. Posted

    Im trying to create some rungs to monitor some PLC Faults.  AC Down, I/O Module Fuse, Op Error, PRG time over, Low Battery, Clock Data, StBy Mode, Annuuciators, LED Instructions. However, I cant figure out what logic to use in order to display these faults as the Addressing is limitted. Can anyone help? 

  10. Posted

    Im trying to create some rungs to monitor some PLC Faults.  AC Down, I/O Module Fuse, Op Error, PRG time over, Low Battery, Clock Data, StBy Mode, Annuuciators, LED Instructions. However, I cant figure out what logic to use in order to display these faults as the Addressing is limitted. Can anyone help?