Kdawg

MrPLC Member
  • Content count

    10
  • Joined

  • Last visited

Everything posted by Kdawg

  1. Mitsubishi Q Series Fault Logic

     kindly thanking Gambit so much! Appreciated the help and information!! 
  2. Im trying to create some rungs to monitor some PLC Faults.  AC Down, I/O Module Fuse, Op Error, PRG time over, Low Battery, Clock Data, StBy Mode, Annuuciators, LED Instructions. However, I cant figure out what logic to use in order to display these faults as the Addressing is limited. Can anyone help? 
  3. Mitsubishi Q Series Fault Logic

    This is what I want to achieve. Just need proper addresses 
  4. Mitsubishi Q Series Fault Logic

    This is the logic . Just need addressing for each alarm
  5. Mitsubishi Q Series Fault Logic

    I’m trying to put in some rungs which will trigger alarms for each of those points. In the manual it states in registers SD 207-SD209? That’s only 3. For 11 different alarms. The manual says it goes by priority but does say when it triggers were it resides. My local rep suggested SD0. But again it’s only one. Would like 11 inputs to trigger 11 (M3000). Can u suggest something? Your help is greatly appreciated 
  6. Im trying to create some rungs to monitor some PLC Faults.  AC Down, I/O Module Fuse, Op Error, PRG time over, Low Battery, Clock Data, StBy Mode, Annuuciators, LED Instructions. However, I cant figure out what logic to use in order to display these faults as the Addressing is limited. Can anyone help? 
  7. Im trying to create some rungs to monitor some PLC Faults.  AC Down, I/O Module Fuse, Op Error, PRG time over, Low Battery, Clock Data, StBy Mode, Annuuciators, LED Instructions. However, I cant figure out what logic to use in order to display these faults as the Addressing is limited. Can anyone help? 
  8. Im trying to create some rungs to monitor some PLC Faults.  AC Down, I/O Module Fuse, Op Error, PRG time over, Low Battery, Clock Data, StBy Mode, Annuuciators, LED Instructions. However, I cant figure out what logic to use in order to display these faults as the Addressing is limited. Can anyone help? 
  9. Im trying to create some rungs to monitor some PLC Faults.  AC Down, I/O Module Fuse, Op Error, PRG time over, Low Battery, Clock Data, StBy Mode, Annuuciators, LED Instructions. However, I cant figure out what logic to use in order to display these faults as the Addressing is limitted. Can anyone help? 
  10. Im trying to create some rungs to monitor some PLC Faults.  AC Down, I/O Module Fuse, Op Error, PRG time over, Low Battery, Clock Data, StBy Mode, Annuuciators, LED Instructions. However, I cant figure out what logic to use in order to display these faults as the Addressing is limitted. Can anyone help?