Kdawg
MrPLC Member-
Content count
10 -
Joined
-
Last visited
Community Reputation
0 NeutralAbout Kdawg
-
Rank
Sparky
Profile Information
- Country United States
-
kindly thanking Gambit so much! Appreciated the help and information!!
-
Kdawg started following Mitsubishi Q Series Fault Logic
-
This is what I want to achieve. Just need proper addresses
-
This is the logic . Just need addressing for each alarm
-
I’m trying to put in some rungs which will trigger alarms for each of those points. In the manual it states in registers SD 207-SD209? That’s only 3. For 11 different alarms. The manual says it goes by priority but does say when it triggers were it resides. My local rep suggested SD0. But again it’s only one. Would like 11 inputs to trigger 11 (M3000). Can u suggest something? Your help is greatly appreciated
-
Im trying to create some rungs to monitor some PLC Faults. AC Down, I/O Module Fuse, Op Error, PRG time over, Low Battery, Clock Data, StBy Mode, Annuuciators, LED Instructions. However, I cant figure out what logic to use in order to display these faults as the Addressing is limited. Can anyone help?
-
Im trying to create some rungs to monitor some PLC Faults. AC Down, I/O Module Fuse, Op Error, PRG time over, Low Battery, Clock Data, StBy Mode, Annuuciators, LED Instructions. However, I cant figure out what logic to use in order to display these faults as the Addressing is limited. Can anyone help?
-
Im trying to create some rungs to monitor some PLC Faults. AC Down, I/O Module Fuse, Op Error, PRG time over, Low Battery, Clock Data, StBy Mode, Annuuciators, LED Instructions. However, I cant figure out what logic to use in order to display these faults as the Addressing is limited. Can anyone help?
-
Im trying to create some rungs to monitor some PLC Faults. AC Down, I/O Module Fuse, Op Error, PRG time over, Low Battery, Clock Data, StBy Mode, Annuuciators, LED Instructions. However, I cant figure out what logic to use in order to display these faults as the Addressing is limited. Can anyone help?
-
Im trying to create some rungs to monitor some PLC Faults. AC Down, I/O Module Fuse, Op Error, PRG time over, Low Battery, Clock Data, StBy Mode, Annuuciators, LED Instructions. However, I cant figure out what logic to use in order to display these faults as the Addressing is limitted. Can anyone help?
-
Im trying to create some rungs to monitor some PLC Faults. AC Down, I/O Module Fuse, Op Error, PRG time over, Low Battery, Clock Data, StBy Mode, Annuuciators, LED Instructions. However, I cant figure out what logic to use in order to display these faults as the Addressing is limitted. Can anyone help?