hendra
MrPLC Member-
Content count
26 -
Joined
-
Last visited
Community Reputation
0 NeutralAbout hendra
-
Rank
-
- Birthday 07/05/06
Contact Methods
- AIM -
-
MSN
hendranugraha@hotma
il.com -
Website URL
http://www.great-sc
ale.com - ICQ 0
-
Yahoo
hendra_ftje2000@yah
oo.com
Profile Information
- Location semarang city
- Country Indonesia
- Interests -
Recent Profile Visitors
1570 profile views
-
Please advice me how to setup password for cpm2a, using cx-p v3.1. i put it in the first rung. Then i click set password, then it shown "error setting system protection, the program is not protected with a FUN(49) function". it won't work regards, hendra
-
i need to connect my CPM2A PLC to several weighing device, can it be done using multidrop communication using RS485???
-
where i can find any sample of programming omron cpm2a with visual basic, i can connect it with vb using active x from cx programmer, but i don't have issue how to read or write PLC data.
-
i wanna use adapter serial (CPM1-CIF01) for my PLC CPM2A, when i plug it to peripheral port the RUN lamp is off, It can turn on only when i connect to PC and click monitor or program toolbar from cx-programmer, then my program can work well, but when i turn off the PLC then i turn on it again the RUN Lamp still OFF, when i unplug the adapter serial the RUN lamp can turn on. Is there any hint to solve it, Thanks
-
i try to remove the battery for more than an hour but the memory still not erased. I will try to borrow CIF from my friend first, btw thanks so much.
-
So i must have adapter serial CPM1-CIF for the peripheral port, or any other solution, because i don't have it.
-
my fault is my ladder is just -----------------------------------------------------------------|TXD | |dm0 | |ar9 | so when i turn on the plc it directly use it serial port to send data, so the comm lamp turn on, and i can't connect again to PC neither the communication switch on or off. And im using serial port, and the setting serial port is default, using hostlink.
-
dear sirs, im using cpm2A, then i try a program transmit data using TXD then i upload it to PLC, after that i cannot connect again to PC and the comm lamp is on. How is the hint to solve it or to reset the PLC, or any other solution. best regards.
-
try to find it manual, i think the setup is failure and making sure to close your program with END operation. keep try
-
How to control stepper motor from floppy disk using cpm2a
-
How to use FUNTION DECODER 7 SEGMENT in cpm2a, and how many output needed if i want to make a single digit 7 segment display