Sign in to follow this  
Followers 0
wave

CJ2M, SCU32, Modbus RTU with 3G3MX2 VFDs

1 post in this topic

Posted (edited)

Hello everyone. I have Omron CJ2M-31 PLC with SCU32 communication unit, and 34 3G3MX2 drives with repeater. I use "Easy to use Modbus RTU Master for CP1L CP1H CJ1 CJ2 CS1" written by our member PMCR (thank you PMCR for sharing your experience). I need to reed VFD status, reset fault, and write the speed. I tried the sample code version 2.12 with a single VFD, but in my test application it works inconsistent. I had got communication in the first place, I could control the drive, but I lost it after program modification and downloading (I did not touch communication part). I was able fix communication only once, and lost it again. I didn't find any correlation between my action and communication presence ( I tested dual port program version). If the communication is present, SCU unit blinks fast, otherwise slow. I have cleaned PLC memory and initialized PLC without any luck.

Unfortunately, PMCR is offline. If anyone is proficient with mentioned above program, please advise where to look.

Thank you in advance. 

Edited by wave

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0