Profibusproblem Mitsubishi FX2N-64DP-M - DKC 3.3

[Guest Guest]

I've got actually a heavy problem with an Mitsubishi FX2N with Profibusmaster. (configuration in attachment) Problem is scantime. When I run the program with only some MT-modules (remote I/O from Mitsubishi) connected, I have a scantime from +/- 6ms. When I connect the 3 servodrives from Indramat (also by Profibus), the scantime is going to 180ms, which is really to slow. Is there a possibility to reduce the scantime ???? I have only 1 or 2 TO and FROM instructions in my program. Does anybody have experience with this ? Thanks a lot in advance !

[kumar 0]

Could you please mail me to the following ID about the FX2N Profibus master. Regards, Kumar.E ek.alvvc@ashokleyland.com

[Guest mohammad ali]

hi : plz send me the logic on my email mohammadali091979@yahoo.com i check it all and then tell you what can we do for it . syed mohammad ali

[Crossbow 296]

You might get more responses to this if you also posted it in the Mitsubishi forum.