Parrafinpower's Conveyor Code

[ToddM 0]

Hi folks...I downloaded Paraffinpower's conveyor sample code but can't get it to open on my copy of CX programmer. I am using version 2.1,is it too old or what? any help would be appreacated. Thanks and later...Todd

[ParaffinPower 13]

Hi Todd More than likely. I wrote it with V6.0 and uses FBs. Were these supported in V2? Anyone any ideas? Pp

[Guest anonymous]

Hello Todd, I don't know what version Parrafinpowers code was written in, but that sounds like what the problem is. Bear in mind that v2.1 would not have supported the CS / CJ -H series. Pp, just looked at the description of your code. FBs were not supported until v5.0 (using '-H' version 3 PLCs only), so unfortunately, there is no way to use CX-P v2.1 with this file Regards anonymous Edited 17 Feb 2006 by anonymous

[ToddM 0]

Bummer Thanks and later....Todd