Master&Sleeve application

[Omronix 0]

Dear All, CPU SLC 5/02..... 0-10VDC analog out module... as example analog output #1 is master ( 0.....10.0 VDC set point comes from Panel Builder) analog output #2 is sleeve... (0.....10.0 VDC set point comes from Panel Builder If master set point increase/decrease 10%; sleeve setpoint should be increase/decrease 10%.. If sleeve set point increase/decrease; master set point will be NOT change. Can someone have an example for this application Thanks in advance

[TConnolly 13]

Only copy the master value to the slave value when the master value changes. master_slave_update.pdf

[Spedley 0]

Only change the slave when the master changes but you must also take into account the current change of the slave. If the master changes by +1 and the slave changes by +2 the slave should change by +3 This especially applies when the analoge signal is noisy.