Omron NT600M-DF122 INTERACTIVE DISPLAY

[Jay Anthony 118]

From PM this afternoon: Files intentionally not included for security purposes - JA

[Jay Anthony 118]

You will have to use NTSS software to load the files that you found on your computer back to the NT600M. See links to software , quickstart guide and serial cables below. NT Support Software V2.33 @ MrPLC.com NTSS 2.33 Quickstart @ MrPLC.com Omron Serial Cables @ MrPLC.com

[Jay Anthony 118]

One other thing: There is a memory card mounted behind the LK201 Host Link Module. Please retreive the card from the old screen and place it in the new screen. NT600M Operation Manual @ MrPLC.com

[Jay Anthony 118]

[Jay Anthony 118]

This cable is fine to download the program. It connects to the programming port found behind the middle door on the back of the unit.

[Jay Anthony 118]

From PM this afternoon:

[Jay Anthony 118]

Please post all furthur requests here at the forum rather than by personal email. You will get a lot more answers because all can see. V002-E1-03 NT600M Operation Manual @ MrPLC.com

[Jay Anthony 118]

From PM this morning:

[Jay Anthony 118]

Please post all furthur requests here at the forum rather than by personal email. You will get a lot more answers because all can see. It is not possible to communicate through the printer port of the computer to the 9-pin serial port on the NT600M. Please describe all steps that you have taken so far.

[Jay Anthony 118]

Please post all furthur requests here at the forum rather than by personal email. You will get a lot more answers because all can see. It is not possible to communicate through the printer port of the computer to the 9-pin serial port on the NT600M. Please describe all steps that you have taken so far. On the side of the display there are four buttons. Press the top three all at once to get to the system menu. Then place the NT600M in the transfer mode.