Posted 23 April I have been using FXGP for programming our PLC's and have been using STL's for my ladders. We are looking to switch to GXdeveloper because FXGP doesn't work with newer versions of windows. I prefer the way FXGP "indents" the STL steps where GXdeveloper does not. I find the indented format much easier to follow. Does anyone have a way to display the STL's in the same format in GXdeveloper or is there something else I can use. I have included a part of a program using both softwares for comparison. FXGP.pdf GXdeveloper.pdf Share this post Link to post Share on other sites
Posted 23 April If you are going to Cange you might aswell change to GX Works 2 which still support the FX series up to FX3. As for STL is was a languge to do SFC. GX Developer and GX Works 2 both support SFC. Have you looked at this ? Share this post Link to post Share on other sites
Posted 23 April I haven't done any programming using SFC. Is anyone used GX works 2 for STL? Does it display the STL's with an "indent:? Share this post Link to post Share on other sites
Posted 23 April Upgrade from GX Developer to GX Works and under option in GX Works 2. Set Display STL instruction in contact format Share this post Link to post Share on other sites
Posted 23 April Gambit, Thank you. Is that option available in GX Developer? Do you have part of a program that you can show in GX works? Share this post Link to post Share on other sites
Posted 23 April Not that i am aware of. Also GX Developer is not supported anymore Share this post Link to post Share on other sites
