Posted 9 January Hello all, and HNY! I have managed to connect direct HMI to drives and change parameters, but this time I want to connect HMI with PLC and a E700NE drive. My set up is PLC and Drive on CC Link IE Field Basic, then HMI via ethernet. I can control drive and have fancy graphs, but what I am struggling is with the Parameter template screen, to change parameter of the drive from HMI. I have tried to set up CH2 with Freqrol E800/E700NE batch monitor, but does not work, not sure what to check/do. does any one have any experience with this type of set up? Cheers. Share this post Link to post Share on other sites
Posted 9 January This is the mitsubishi example project FR_GT27.GTX 1 person likes this Share this post Link to post Share on other sites
Posted 9 January Thank you Gambit, I got the Sample Screen Manual, but its not working when I add CH2 for the PLC. Closest I got it to work "ish" still no parameters being written, is with the standard E700 template, in the system library modified for E700NE variant. Then when I use the parameter is when it does not work. CBelectrotech.GTX Share this post Link to post Share on other sites
Posted 10 January Well i did see that the network nr of the GOT for the Drive is set to 1 and for the E700 network 2. This could be the problem Share this post Link to post Share on other sites
Posted 10 January Hello, yeah, I am desperate and trying anything, I say in the template you sent me, which i found the manual for it, it does that? Since you have 1 cc link IEFB drive only, this will be Network 1 station 1, but somehow conflits with the FX5. My next step is setting it up as station 2, but i still dont understand why, it should be possible to do it, without so much faffing about... Cheers!! Share this post Link to post Share on other sites