GOT2000 DIRECT TO D700 PU PORT

[FRANK RUIZ 2]

Hello Every body Peeps,

I downloaded the GOT2000 comms manual where it describes how to connect to the D700 DIRECT on the PU port.

I then placed the D700 template of the HMI from GT Designer 3 onto a GS2107WTBD. Parametized the drive, etc.

 

In the template  I changed the devices to match the station of my drive which is 1. i.e. on the template I had Device 0-0 SP122, for start forward, i then put my station no. 0-1 SP122, and that works.

 

However, other than that, and the stop nothing else works, despite changing the station no. on devices, but I read in manual that if Pr 37 not 0 and SP127 = 1, then HMi cannot monitor SP109-111 which are devices used in my amps and speed setting, which they are not displaying on HMI.

I can change Pr 37 to anything other than 0, but i have no idea how to change SP127, which description is Link parameter extended setting.

 

Any ideas?

 

Thanks.

[VeeB 8]

Hi Frank,
On the D700 side:
Pr. 117=0, Pr. 118=192, Pr. 119=10(7, 1stopbit), Pr.120=1(odd), Pr. 123=50 (comm wait time), Pr 549=0
Pr. 340=10 (Net mode on startup)

Please note an older GS2107-WTBD does not support RS485. (the new WTBD-N does support) So I connected via the SC-FRPC programming cable on the RS232 port of the GOT.
I got here only the old version of the GS2110 HMI. See attached sample I used successfully.

Good luck!

SmallDemoGS21.GTX

[FRANK RUIZ 2]

nice one! cheers.

[FRANK RUIZ 2]

On 09/08/2023 at 3:19 PM, VeeB said:

Hi Frank,
On the D700 side:
Pr. 117=0, Pr. 118=192, Pr. 119=10(7, 1stopbit), Pr.120=1(odd), Pr. 123=50 (comm wait time), Pr 549=0
Pr. 340=10 (Net mode on startup)

Please note an older GS2107-WTBD does not support RS485. (the new WTBD-N does support) So I connected via the SC-FRPC programming cable on the RS232 port of the GOT.
I got here only the old version of the GS2110 HMI. See attached sample I used successfully.

Good luck!

SmallDemoGS21.GTX

I tried your software, still nothing works.

i have tripple double, and more times checked the pin out in my cable, everyone i have asked says it is correct.

I must be doing something wrong in the software then.

I am connecting my GT2107 direct from RS422/485 to PU port on D700

my devices are then for 1 station only. The Got communication manual says i have to set up Got terminating resistor at 330

see attached picture.

my cable pins are on RJ45 1 brown, then 3 is green, 6 is white green, 5 is blue, 4 is white blue

the connection to the RS422/485 is 

PIN RJ45 to RS422/485

5 to 2

4 to 7

3 to 1

6 to 6

1 to 5

 

What could i have wrong?

 

Any one help!!