Schneider Concept 2.6 connect to Momentum PLC

[Fets 0]

Good morning,

      New to Schneider PLC's. Purchased Schneider Concept 2.6. Installed on older XP laptop. Software loaded fine on the laptop. The PLC I am trying to connect to and save the existing program is a Schneider Momentum PN 171CCC98030 through the 9 pin port. The ethernet port maybe locked up. I have (2) questions:

1) What is the correct Cable and Part number needed for this

2) What is the steps needed to save the save the existing program that is in the PLC. Need to save it on my laptop. 

Thank you for your help in advance....

 

 

[Crossbow 304]

The 9 pin port is RS485, so at a minimum you will need an RS232 to RS485 converter, if you can even program it that way.

I've only ever programmed those over the Ethernet port, and that was 2 decades ago.