Micrologix 1100 - no outputs

[LURBY 1]

I acquired a Micrologix 1100 (1763L16BWA) from eBay.  It was supposedly new but it wasn't.  It had a fault immediately after power up.  I cleared the fault (without reading the number stupidly).  It cleared and I loaded my program.  Everything works in run mode except for the outputs.  When I call for an output the screen shows that the output is made but I have no continuity across it.  None of them work.  Has anyone seen this before?  The program is functioning properly.  I am controlling Powerflex 525 drives over Ethernet and that part works fine.  It's just the outputs.

 

Any wisdom would be appreciated! Thanks

[BobLfoot 302]

The unit you have is relay outputs which are rated 10 mikkion cycles until you read the fine print and see they're actually rated for 30 thousand cycles in some applications.  while not likely they all failed they are relays.