Printing in larger font?

[Ron_S 61]

I'm writing a program for an FX3 in GX  Works 2.

The program has 300 M relays that will operate Y outputs (not 300 outputs - several M relays per output)

All the outputs will be together at the bottom of the program ie LD M0, OR M1 OR M2 OUT Y0 etc etc

So I printed the 'comments only' out to read off the sheets to help me program the outputs (quicker than going back and forth in the program or hand writing them)

But, the print font is so small I can barely read them - even with my glasses on and can't follow the comments to the M relay.

I have tried in printer setup to make the font bigger (it was set at 12) but makes no difference - same tiny print.

 

Any help?

 

EDIT. hard programming for hours dulls your brain. But it might help someone else.

If you change the print font size in GX Works 2, you have to close the program and re-open it for it to work.

Edited 30 Jul 2021 by Ron_S