C200HE

[wonderboutin 0]

I want to xfert data of my c200he to a cs1 with rs232 (comA) but my problem is to config the com because I want the c200he for master. What is the config of two comm and what is the instruction? tanks!

[ahuat 0]

hello, in c200he : rs232C in cs1 : host link regards ahuat

[wonderboutin 0]

o.k I configure c200he in rs232c and cs1 in host link. I use the instruction SEND in the c200he but is not work. Can you help me ?

[ECSI 17]

The SEND instruction is for networks such as Ethernet, Controller Link, etc. For a serial connection you should use Transmit/Receive (TXD/RXD) instructions and use Host Link commands such as Write IR Area (WR) and Write DM Area (WD). There is lots of Host Link info if you browse this forum and download area. Check out ahuat's last topic to get started... Master Slave Topic Also check out the C200HE Operation manual section 8 for info on serial comm.