Posted 2 May 2017 hi everyone I'm a begginer on CX-programmer and i'm trying to find out how to combine the 4-20 mA input signal from AD081-V1 analog input card to 0-10V output signal of AD041 analog output card?? I m using Omron CJ1M-CPU11. Please help if you may Share this post Link to post Share on other sites
Posted 2 May 2017 Welcome to the forum. I would suggest you start by reviewing the manual for the modules. Please see the link below. The manual will explain the addressing for these modules and where the data is located in plc memory. https://downloads.omron.eu/IAB/Products/Automation Systems/PLCs/Modular PLC Series/CJ1G, CJ1H/CJ1 Analog IO and Control Units/W345/W345-E1-11+CS-CJ-Series+OperManual.pdf If you are trying to send the analog input value to the analog output module, take a look at the MOV instruction. Hope this will help. Share this post Link to post Share on other sites