Industrial PC Comm issue after power outage

[phuz 2]

I'm working with an Industrial PC (6182) that was running fine until a power outage. After a reboot, RSView Runtime will not communicate with the SLC 5/05. The PLC is visible from within RSLinx, and all the node information is still intact in the RSView setup. Since the PLC is visible, I'm not sure why RSView is having trouble communicating. Edited 12 Dec 2013 by phuz

[phuz 2]

It turns out that the PC lost the Linx activation and when rebooted, came back up in Classic Lite mode, killing the OPC portion.