omron conversion ns5 to ns10

[sttchui 1]

Hi, I am converting ns5 to ns10 touch screen, but after converting the on/off button after i press it will pop up a keypad, but the on/off buton will went missing after that, is there other settingi need to configure which i left out? I only change the model from the cx designer? Thank you Regards, Sttchui

[PMCR 66]

When you convert from a larger screen to a smaller screen, the objects are not automatically resized. So, most likely the objects that are 'missing' are simply off the screen. Change the Zoom to 100% (or smaller if needed) to see all the objects that are off the screen. You will need to open each screen and resize the objects. You can select all the objects, and then grab the corner of one and resize all the objects at once.