Posted 13 Aug 2012 Hi, I am creating a fault mapping logic, where in i want to access bit of a DINT Data type, For which i have created a symbol at Address H10 and declared it as array of 32. When i am Trying to access the bit of the following array i am getting an error. Please find the Program & Error in the attachment my Question is how i will access each Bit of the above array? Please help out with solution. Thanks Vijaya Share this post Link to post Share on other sites
Posted 13 Aug 2012 The WARNING you are getting is only a Warning, not an ERROR. Your program should still compile even with this WARNING. In CX Programmer you can edit the program checking options from the PLC menu then Program Check Options... Share this post Link to post Share on other sites
Posted 14 Aug 2012 (edited) You can turn off the duplicate output warning by changing the "Program Check" options under the "PLC" tab if it bothers you. Edited 14 Aug 2012 by Mendon Systems Share this post Link to post Share on other sites
Posted 14 Aug 2012 Hi Sparky, Thanks for your Answers... But i want to make sure that i am correct while accessing the Bit of the DINT as shown in my attachment? Share this post Link to post Share on other sites