Q64DAN

[plcdp 11]

Hello, I am doing a project with a Q-series PLC using GX Works2. I have 2 analog output modules. (Q64DAN). When I am configuring the intelligent module through the "wizzard", the output value is selectable, be it 4-20ma, 0-5vdc, etc. There is an option for "User defined output". I would like to use this to get a 0-10vdc output but I can't seem to find where such definition is made. Any insight on this would be greatly appreciated. Thanks, plcdp

[Gambit 330]

You can choose -10 to 10V. only a negative value will output a negative voltage.

[plcdp 11]

I see....Thanks