Automatic refresh setting in multiple cpu system using simulator using melsoft navigator

[servo_hunts 0]

Dear All, Can i check the Automatic refresh setting in multiple cpu system using simulator of melsoft navigator(melsoft iQ works)? Servo_Hunts Edited 6 Apr 2011 by servo_hunts

[kaare_t 155]

You can set up Autorefresh under PLC Parameter. Is this what you mean?

[servo_hunts 0]

I already set the autorefresh setting in GX WORKS2 and MT WORKS2,but in simulator i have to checked that if i will Forced ON "M0" bit from PLC then will i get status of that bit in motion program OR not?

[kaare_t 155]

Not sure how this will work in Simulator mode..... Someone else??

[servo_hunts 0]

same one i checked with GT WORKS3 and GX WORKS,it's running properly. Servo_Hunts Edited 9 Apr 2011 by servo_hunts