programming OMRON NT631C-ST141-EV2 HMI

[gendy 0]

HI I have OMRON NT631C-ST141-EV2 HMI, with broken part of glass so I can't operate it in that part Could any one advice me how I repair it, I want to make upload for the application program, what software and cable I need? If I found another module with the same model number Is there any debut , if I replace my broken screen with the screen of that module I will face any problems?? Like firmware mismatch or something like that The glass part have this number G.T. /GUNZE U.S.P 4.484 .038 The LCD unit EDMGRA3KCF Matsushita Electric industrial Co , LTD

[nasir_ash 0]

Dear you need NT-Support Tool software and NT-System installer which you can get from CX-ONE software packge. if you have the exact same model of spares then you can swap the screen then you can upload the application by using NT-support tool. For more you can take help from the manual V063-E1-03 NT631 and 631C setup manual from the OMRON WEBSITE. you can find the how to maek cable for communication in the above manual. regards NASIR