Reset Coms on micrologix 1000

[Mark Empson 0]

Any one got any ideas on how to revert the coms on a MicroLogix 1000 back to default from DF1 slave half duplex? Client has a unit which was accidently set to DF1 slave half duplex and now can not communicate with it. Best regards, Mark. Edited 4 Jun 2010 by Mark Empson

[Mickey 71]

Try the "DF1 Polling Master driver" in RsLinx Or if your PC has a real serial port you can use the 1747-PIC/AIC+ driver(DH485) ( see PDF below for more about auto protocol switching for your ML1000) AutoProtocolSwitching.pdf