RSLogix500 1762-IF2OF2

[zoldak 0]

Hello I am trying to add a sorensen power supply to generic controller I have with no success. I have a sorensen power supply configured to accept varying voltages from my 24 volt I/O card. I am unsure how to program my PLC to set the voltage of the supply. I have my power supply set up to accept 0 - 10 VDC input to set the voltage however I am unsure on how to code this using RS Logix 500. Any Ideas??

[Ken Moore 23]

This may get you started in the right direction, this example assumes output 1.0 is your output, you can vary the output by changing the value in N7:0, if your controller is new enough, you can replace N7:0 with a floating point.