Posted 19 Dec 2007 Dear all I use a micrologix 1200 with an IF2OF2 and an IF4 from the IF2OF2 i am driving to motor via 0 to 10v signal I have a speed feedback from the driver connected to the IF4 to check my speed rate. From know i do not have the corect cable for good wirring, so i connected my speed feed back directy to the output, and i do not have same value from output 1 and input 1 any idea ? Share this post Link to post Share on other sites
Posted 19 Dec 2007 I find out, i miss to change the switch position for voltage input Share this post Link to post Share on other sites