Swap I/O table

[beegee 7]

Hi, We have a lot of CJ1M plcs in the field and noow customers (far away) start asking for the possibility to have remote maintenance throug ethernet. I would like to send them a preconfigured ETN021 board and let them plug it in on the PLC. The only problem is I have to regenerate a new I/O table for that installation, so I have to go on-site. In the future I want to prepare our machines in software to be able to have an extra comms card connected onto the board. Does anybody knows if it is possible to generate a new I/O table in ladder? Thx Beegee

[Guest anonymous]

Hello Beegee, Not sure if this will help, but checkout Jays reply to this thread... http://forums.mrplc.com/index.php?showtopi...amp;hl=IO+Table See Section 8-2 of W393 CJ Operations manual. Hope this helps Regards anonymous Edited 14 Nov 2007 by anonymous