FX-10GM Cable programming

[fasagianghanoi 0]

Dear all, Please help me !! I want to download program from FX-10GM to upload new set . I know this programming port of FX-10GM is 20 pins. I only have cable programming for FX but 25pins If anybody knew please help me ! Thank you very much for yours help . Best regards Lam

[Crossbow 297]

According to the manuals, this requires the E-20TP teach pendant or FX-PCS-KIT-GM-EE.

[fasagianghanoi 0]

Dear Mr Crossbow Could you sent me drawing of cable RS 422 from 25pin -> 20pin ? Because connector of FX-10GM is 20pin . I would like to connect FX-10GM to PC so please help me . Thank you so much Lam

[Crossbow 297]

No I cannot send you a pinout because I do not have one. All I can tell you is what it says in the manual for the part number for the cable. I don't know any more about that module. You should contact your local Mitsubishi office or distributor for support.

[fasagianghanoi 0]

Dear Mr Crossbow, Thank you so much for your support . Best regards Lam

[Crossbow 297]

The FX-10GM was for the older FX series. He does not mean the FX2N-10GM.