Search the Community

Hello All, I want to read data from a Control Logix PLC, into a PLC5/60, using Ethernet and a MSG instruction in the PLC5. When verifying the MSG instruction in the PLC5, I get an error message. "Target Address in invalid". Once I figure out how to do this I need to replicate it in another PLC5. Scope is to read the status of 4 paint pumps controlled by the CLX. If any of the 4 stop, the PLC5 needs to know, because it is controlling the paint application equipment. Source data resides in a Control Logix 1756-L63. The tag is INT type, 4 elements long, and the name is PUMP_STS_B2. The IP address of the CLX is 4.2.6.230. There are 2 ENBT cards, one in slot 1, and the other in slot 3. 4.2.6.230 is slot 3. PLC2,5 / SLC Mapping has been created in the CLX. File=421 Name PUMP_STS_B1 and File=422 Name Pump_STS_B2. The file mappings represent a binary file created in each of the PLC5's B421:0~4 in Booth 1, and B422:0~4 in Booth 2. The PLC5/60 is Enhanced series E model using the Ethernet side card. The IP address of the PLC5 is 3.26.5.61. I also created MG file types in each of the PLC5/60. MG420:0~19 in each processor. This was necessary to use the MSG instruction in the PLC5. I have searched the forums for examples of how to do this with no solid results. I am trying to follow the best practices of reading the data into my PLC so anyone who follows can tell where it is coming from. While the IP addresses are not closely related they should be able to communicate. I say this because all of our PC's are on the 4.2.6.XXX network on a 255.255.252.0 sub net and we have no issue communicating with the 3.26.5.61 IP address. Any help and advice would be greatly appreciated. Regards, Mike Carter

Hi dear all , i need some helping .. I used CJ2M cpu31, then i want to send data (example D100 = 2000) to PC ...essentially i want send value 2000 to my PC.. wherein the PC and PLC conect via internet IP .. What should tool/software may i used ? Thanks before ..

I have the following situation; I have a distribution network connecting about 400 RTUs, using 101 protocol to connect to their PDH MUX, which data slot is transported using SDH STM-1/4, to the Primary Substations. Then the primary substations connect to the LDC building using STM-16. At the Control Centre Building where the Front End is located, there is a STM-16 node with some PDH ports, but definetly not 400, so how can I extract this 101 asyncronous data channels to connect them to the SCADA Front End? Note that conversion to 104 is not allowed by the client. Thanks in advance!