Search the Community

Showing results for tags 'delta mitsubishi'.

  • Search By Tags

    Type tags separated by commas.

  • Search By Author

Content Type

Find results in...

Find results that...


Date Created

Last Updated

Filter by number of...

Found 380 results

  1. Programming Error using QJ71C24N

    Husanto posted a topic in Mitsubishi

    Hi All, I have problem about programming serial module Mitsubishi PLC using QJ71C24N. If I unconnect the cable from the module and connect again it show SIO error and the communication become lost or not sending data again. so i have to restart the PLC to make it normal again. Any other solution for solve this error without restart the PLC? Thanks Husanto

  2. Non-volatile memory GX Works2

    williamj posted a topic in Mitsubishi

    Hi all, Im trying to figure out how to create non-volatile memory tags in GX Works 2 (using a FX3U controller), so that the values stored in the D registers won't keep zeroing out every time the controller powers down. Does anyone have any helpful tips on how this is done? Thanks

  3. Mitsubishi QJ71PB92V and Balluff BNI PBS-507-000-Z011

    semenyuk.serg@gmail.com posted a topic in Mitsubishi

    Hi all! I need advice. I have Mitsubishi Q02UCPU with profibus module QJ71PB92V. I try to connect communication module from Balluff BNI PBS-507-000-Z011 via Profubus without success. Everytime I connect module, I see diagnostic alarm "The parameter transmitted by the master is incorrect". All settings were made by default. QJ71PB92V has 0 adress and Balluff BNI PBS-507-000-Z01 has 11. I connected this module to the Siemens CPU-315 and it is work correct. From this forum I see it is common error. What will be the next step to check or solve the problem? I am not profficient in Profibus networks, so I will be appreciate for any help!

  4. Help with carwash / FX3

    jrrice72 posted a topic in Mitsubishi

    Can anyone help with a carwash program? I am currently a student and having a very hard time getting this to work. I am using GX2 software. Any help would be greatly appreciated. Jeff
  5. Dear experts, I have been trying to flash parameter to QD75MH1 module from PLC. Every time I monitor the servo via GX-configurator QP, I find 0 error, 0 warning but in the history tab it shows "start not possible(108)". But when I did it by flashing the parameter by GX-Configurator QP(Specially invalidating forced stop option" it works fine and servo motor jogs. can anyone help me to write the forced stop value from PLC program?