Glenn Covington

MrPLC Member
 View profile  See their activity

  • Content count

    10

  • Joined

  • Last visited

Posts posted by Glenn Covington

  2. Posted

    How many different stop locations are needed.   In other machines I have seen a small turret block with various lengths of set screws that could be turned manually to the desired stop position.   The cylinder would have a tab attached to the rod end that contacted the various length set screws to position cylinder.

    1 person likes this

  5. Posted

    Good morning.   I have a GT1655 HMI I want to use but the mounting hardware is missing.   Anyone know a part number or source to buy the metal screw hardware tabs to tighten the GOT into the enclosure?

  7. Posted

    Hello all.   I am having trouble with communication between an IAI PCON controller on CC-LINK IE network and a Mitsubishi Q-series (UDV) processor.   There is a master CC-Link IE card in the PLC rack.   The PCON controller has multiple control strategies.   We are trying to use the full direct value mode.   The CPS file was added to the configuration for the CC-Link IE network configuration.

    Unfortunately we have only been able to write information, or read information, but not both.   Has anyone commissioned an IAI PCON on CC-Link IE that might be able to give some guidance?

    Thanks,

    Glenn

  8. Posted

    Hello all.   This may be a very basic question, but I am confused about the varieties of CC-Link IE Field networks.   There are 3 listed, Basic, Field, and TSN.   Basic runs at 10 MBS and the others at 1 GBPS.   My question is if you have a CC-Link Field network, can you put a CC-Link Field Basic device on that network?  The cabling is the same (Cat 5E).