The Jamaican

MrPLC Member
 View profile  See their activity

  • Content count

    4

  • Joined

  • Last visited

Community Reputation

0 Neutral

About The Jamaican

  • Rank
    Hi, I am New!

Profile Information

  • Country Jamaica

  1. Change CPM1A mode in code to allow saving flash DM

    The Jamaican replied to The Jamaican's topic in CX-Programmer

    Yes and any Programming Device doesn't mean a terminal device I guess, so it cannot be done. 

  2. Change CPM1A mode in code to allow saving flash DM

    The Jamaican replied to The Jamaican's topic in CX-Programmer

    I tried using CX Programmer to change the DM6614 address but it only keeps the value when I make the change in Program mode.  In monitor mode, the value automatically reverts to what it was before.  Unless the NT terminal does something different, it doesn't look to me like writing to flash will work.
  3. The Jamaican started following Change CPM1A mode in code to allow saving flash DM

  4. Change CPM1A mode in code to allow saving flash DM

    The Jamaican replied to The Jamaican's topic in CX-Programmer

    I am using CX Programmer.  Will writing to the DM66xx memory actually store it in flash so that it remains there even after the Capacitor backup goes dead?  The literature says that you have to change modes to do this.  I have a generator application where the unit can be off for months and want to keep custom setting entered by the customer.  Thanks,
  5. Hello, I want to save some values in flash on the CPM1A. The manual makes it seem that this is possible if the mode of the CPM1A is changed from Run-to-Monitor-to-Run or Monitor-to-Run-to-Monitor.  I have an NTS2.  How do I change modes and will this write the DM66xx values to flash?  I want to know if it is possible before changing the NT2S setup. Thanks,