PJR

MrPLC Member
  • Content count

    2
  • Joined

  • Last visited

Community Reputation

0 Neutral

About PJR

  • Rank
    Hi, I am New!

Profile Information

  • Country United States
  1. MAPC

    I am in the process of making our Kinetix 6000 run using a MAPC instruction.  I know that the master controls the slave and I want to set it up to where my encoder is the master. Motion is new to me and I'm not sure exactly how to do this and I need to make some headway soon and don't have a lot of time for trial runs.  The line I'm putting this on runs a material that is between plastic and rubber. (It's actually separators that go in batteries) Our chop lengths change based on the profile we are running and when we run long chop lengths the material will bunch up on the chopper blade because it runs at a constant speed based off of line speed, length of chop, roll diameter and encoder counts. If I understand this MAPC instruction right it should allow the blade to speed up and slow (hence camming through the material) Any feedback would be very much appreciated!
  2. 1734-IT2I

    I have calibrated my thermocouple card as it says in the manual. 0-70mv.  style J thermocouple is selected and I have Fahrenheit selected but when I send it 100 degrees it reads 490. When I change it to Celsius it reads 95. Not sure what I'm missing? I've been through the manual and I may be overlooking it.  I'm using logix designer 5000 also.  Any help would be greatly appreciated.