Sprudle

MrPLC Member
  • Content count

    9
  • Joined

  • Last visited

Community Reputation

0 Neutral

About Sprudle

  • Rank
    Newbie
  • Birthday 09/16/93

Profile Information

  • Gender Male
  • Country Norway
  1. Hi   I want to look into a program i recieved, but i get this error when trying to open it. Im running the 30day trial atm, but i got the same error when I ran the 1.45 version earlier.   Never used sysmac before, so if anyone has a tip, it would be nice
  2. PLC TO HMI

    PLS: Programmerbar logisk styring = PLC: Programmable Logic Controller   The same   Sry for language mix!
  3. PID regulation PT

    Hello   Does someone have a good way to control pressure using PID in cx-programmer? I got two pumps and one PT(4-20mA) Half the year only one pump need`s to run (about 3bar)  but in the season (i work in a fabric) two pumps need to be running (about 4bar needed) except in the night. I`m going to use HMI for adjusting the setpoint so there is no need for any clock/date for this to change itself. The question is how to get one of the pumps to shut down when the need for pressure is not so high. And get the pumps to change "main" pump sometimes so one pump is not running all the time.   Hope this was understandable    
  4. PLC TO HMI

  5. PLC TO HMI

    Thank you so much for your help!     A new question: Anyone got a nice idea for PID control when controlling two pumps with only one pressure transmitter? (4-20mA)  
  6. PLC TO HMI

    This one?
  7. PLC TO HMI

    the "IO Table and Unit Setup" option is missing in CX-Programmer    The "I/O Table and Unit Setup option" is missing in CX-programmer (left side under the PLS) and is greyed out under PLC-->Edit--> tab.   Is this the only way to fix it? https://www.myomron.com/index.php?action=kb&article=1384
  8. PLC TO HMI

    Thank you for answering! I will try this first in the morning and let you know
  9. PLC TO HMI

    Hi I am a beginner within PLC, I have attended high school and will attend an oral and practical test in January. To become a "licensed" automatician. Total 4.5 years of school and practice. (NORWAY) I have programmed a little omron before, but not with HMI I'm having trouble getting plc to communicate with HMI. I get CX-Designer to communicate with both PLC and HMI.   Hardware: CP1L-EL20DT1-D     NS5-SQ11B-V2     W4S1-03B     Omron 3-port basic ethernet switch 3x Ethernet Cat.6 patch cable   Thanks for reply