plc.mitsubishi

MrPLC Member
  • Content count

    3
  • Joined

  • Last visited

Community Reputation

0 Neutral

About plc.mitsubishi

  • Rank
    Hi, I am New!

Profile Information

  • Country United States
  1. FX5 PLC loses impulses from encoder

    I replaced with a new encoder, but that doesn;t solve the problem. So we can rule out mechanical issues.
  2. FX5 PLC loses impulses from encoder

    Yes, i setup "2phase 1Multiple". For parameter: High speed counter ch1 i have A for X0, and B for X1.  Encoder could correspond 10000rpm, at 1,5Hz on the inverter, shaft of encoder rotates with 41,4 rpm. HIOEN function is required to starts and stops high-speed counting. I deleted EI function but that does not solve the problem.  
  3. FX5 PLC loses impulses from encoder

    Hello everyone!I have strange problem.I have plc, inverter (mitsubishi), incremental encoder (sick) and motor.When i set the frequency on the inverter about 1,5Hz, the plc correctly counts impulses, but every higher frequency causes the plc counts impulses incorrectly or doesnt count.  Above described things are happening at the rotation of motor in the forward direction. With a rotation of the motor to the rear, high-speed counter doesn't count the impulses.All the parameters of high-speed counters and PLC program i am sure there are right ( i'm using only instruction to start high-speed counting (HIOEN) and to enable interrupt (EI).  Input Response Time i had on "No setting" or 10micro-s and nothing.Type of encoder - A/B phase, HTL.PLC - FX5UPLC program - Gx works 3.Maybe somebody had similar problem? Maybe somebody could tell me where i need to look for the solve?   Thanks for help :)