Zubair Malik

Hi I am using Mitsubishi FX1N-14MR. I want to use OP320 HMI with this plc as display device.  Now I want to display a digital counter on OP320, can you please tell me that how can I derive a digital counter from plc and display it on OP320 HMI.   THANKS

I used relay and its working great... Your suggestion worked very well. Thanks for all people being so kind.

I'hv tried this already, but its not working

Thanks for your response. you are great people. Please see the attached image for my logic program. When the signal comes to X3 the process starts but its not get complete it the signal is off at X3. Please help me on this.    

Hi, I am trying to make a program which runs a complete procedure with a set of timers when X3 gets a signal. I am using | | x003 for input and facing a problem that when the signal is received in x3 the procedure starts but aborted when the signal is go off. The signal at x3 comes for a while and the procedure will be finished in about 15 seconds.   My problem is that as the signal stops, the procedure is also stop. I want that once the signal is received at X3, the procedure should start and run until finished even the signal at X3 get stopped.   Thanks

I checked.. Its welded on.. Can anyone plz tell that why it happened?

Thanks for your response I want to use a Digital Value display and you are right here that we can get a countrer from plc output. You said we should use transistore to avoid miscounting, can you please explain it for me and plz suggest me a digital display value device I can use. Please guide me in detail as I am very new with PLC.   Thanks

S/S is connected to 24VDC(N).

Thanks for ur response. I m getting 24vdc from a power supply which gets the 220VAC and convert it to 24VDC.  

Hi, I am using Mistubishi Fx1N. I want to attach a Digital counter with It. Please suggest me that which type of device should I use to count and display it the signal received each time from PLC. THANKS

Hi, I am using the MITSUBISHI FX1N-14R with the following wiring(Please see the attached image). I programmed it as when X1 gets 24VDC it turns on the a Bulb on Y1. When I executed it on my PLC, it worked OK for 3 or 4 time, after that the bulb is always on, its not turning off even I Reset the powers of PLC and the Bulb. Whenever I just turn on the power the Bulb gets turn on and not getting off even if there is no 12VDC in X1 I think I have lost Y1(I mean the Y1 is short circuit). Can you please tell me that whats wrong with my wiring and why I lost the Y1 and can I recover Y1?   Thanks

Set and reset workd nicely Thanks

Hi I have Mitsubishi Fx1n-14 mr. I just made a program in which i put a single contact x1 and a single coil y1. Now when i give the input in x1 it turns on the y1 and when i stop the input in x1 it closes the y1. Now what i want is When i give an input to x1 it should turn on the y1 and keep it on even after there is no input in x1 and turn it off when i give input to x2. How we will program this?  

Thanks to all guys for their support. I have got what i wanted exactly

Hi I have a used FX1N-14MR plc, there is already a program in it which is password protected, but i m not interested in that. My question is that how i can remove the existing program from plc and upload my own program into plc from my pc? Thanks