johneedw
MrPLC Member-
Content count
15 -
Joined
-
Last visited
Posts posted by johneedw
-
-
Dear friends,
I need to build a programming cable for HMI micro panel type (MICRO INNOVATION AG) , the user guide for the panel is showing the programming port (RS232)from the panel side but does not shows the opposite side of the cable(PC side)!..
Please, can you deduce the both sides configuration from the attached image?..
Help me please... -
-
Hello friend,
I'm facing a problem with a servo drives controlled by s7-300 PLC and aSIPRO SIAX 300 panel..
I need to know the meaning the pin assignment of the panel side which controlling the servo drives.The attached image showing the pin symbols(FA1,FB1,Z,.......) and I need to help me to understand these symbols to try to test it !..
Waiting for kind help -
-
Dear Dekor,
Thank you very much for kind interest, of course your reply will increase my expert because its a new idea for me.
But also, i need to learn how to make RS f.flop to be flashing !..
Thank you..
-
Dear friends,
I want to get a flashing output from S7-200 PLC , I've design a simple ladder
to do this but the output doesn't flashing yet!..
The attached image is showing the RS f.flop i designed which doesn't flashing !.
Please advice me to make this circuit flashing !..
Waiting for kind help !...
-
Dear Friends,
Finally my omron panel communicated with the PC according to your's advice and now it is functioning successfully.
Thank you for kind interest and help.
-
-
Because the panel is new and empty , hence I need to download it with the operating system
to run on the machine !...Thank you
-
Dear friends,
Thank you for kind replies..
I need to login to the panel configuration and see its serial port setting to set the (RS232)port of the PC according it .
I've try the method shown in the attachment to login but the panel does not login yet and it says only (INSTALL MODE 1.3)! ..
Help me please to login to the system menu..
Thank you
-
Thank you very much dear Michael..
But I've a two cable configurations, the 1'st which you post and the 2nd which i got from the machine manufacturer and typed in my post
in this page.. Please advice me which one should I depend?..
Note: I'm using (NT Series Support tool) software..
Thank you
-
Dear Michael,
I've made your cable configuration , but the problem remained the same !.. help me plz !..
-
-
Applicom PCI board
in Siemens
Posted · Edited by johneedw
Dears,
I've Industrial computer containing applicom PCI Board 32K which connecting to S7-300 PLC. The hard disk of the computer has fault and then I replaced it with a new one and then restored the system image of drive (C) to the new one correctly but the applicom PCI Board has lost the communication with the PLC !..
I've executed the applicom application restore correctly but when I try to initialize it, its failed to initialize !..
The attached images are showing the details..
Help me please to resume the communication with PLC !..
Waiting for kind help !...