MrPLC Member
  • Content count

  • Joined

  • Last visited

Community Reputation

0 Neutral

About Randy765432

  • Rank

Profile Information

  • Country United States
  1. Has anyone used a LXM32 or an other Schneider Electric drive to a Kollmorgen servo motor? If so what needs to be done?    
  2. I did find the Red Lion protocol converter worked well, only with the PLC 5/20E processor with "E" ethernet. Randy  
  3. I am looking for a device to allow communications to and from a series 5 Allen Bradley DH+ to a Schneider Electric M241 Ethernet IP. Or what is the best way to configure the M241 and third party communications module to allow the communications to DH+. Randy
  4. Thanks for the info. It seems to be working well after since I tied all DC power supply commons and the linear position feed back to DC common. Randy    
  5. Having problems with the analog drifting. Over time the counts change. I have checked grounding and have tied the analog common to the DC common which helped clean up the noise. I am using a Balluff analog linear sensor 0 - 10vdc for the iputs. Both channels seems to drift. Any Thoughts?