Hello MTomczak, What type of communications are you using to send your signal to the Keyence? What Keyence setup are you using, a vision system (with controller) or a vision sensor (IV series)? If it is Ethernet/Profinet then I would suggest downloading their manuals on their vision website for setting up communications. They also have the .eds files available for communications. This is for the IV series, this is a vision sensor that is only the camera. If it is directly wired I would check the voltage on the output card, then check that the wires are going to their intended (and correct) place for the Keyence trigger. TRG1 input is the triggering for camera 1 on the CV-X series, this is a vision system that includes a controller. Hopefully this helps a little bit, with more information someone might be more insightful
