Hello, I have been trying to obtain the software Proficy ME to a GE Fanuc series 90-30 plc and am having no such luck. I called GE who then turned me over to my local distributors. My local distributors said they could not obtain the software because their system was saying it was obsolete. I called GE back and tech support tells me he has several copies in stock but cannot sell one to me because of the written agreement between GE and the distributors. I found several on PLC center, so I give them a call to see how fast I can get it shipped in (they only had the factory 3-4 weeks ship time) I need this software pretty quick. They tell me they haven't updated the site for this item and has been since December since they sold a copy of the software so they are not 100% positive they can even get it. Does anyone know of a cross-reference software that I can purchase instead? What should I do? Does anyone know where I can purchase the software other than from the listed groups above? If GE won't sell it to me directly and my suppliers can't get a copy to sell me, doesn't seem like much help. I was just hoping someone could point me in the right direction, after sitting on hold for several hours and more or less writing a 25 page essay through google I'm losing hope. Also, if someone could send me the pin out for the cable I would appreciate that too. I was going to purchase one, but enjoy making my own. Thanks in advance! The part number I was given was IC646MPS001