I am a student in my graduating year of post secondary school. I am trying to use the Powermonitor 3000 via DNET, using a compactlogix's control system with a 1769-SDN module to communicate with the PM 3000. I currently have comms working between the local chassis and the PM 3000, but am struggling a lot with config of the PM3000. I understand there are data tables, which I must pull as a complete table, using explicit messaging to configure what data I would like to pull from the PM 3000. However, I have never used explicit messaging before, and it seems that is the only way to setup your parameters to pull data from the PM 3000. Does anyone have any tips or starter points on how to tackle this task? I have tried going on AB Knowledge base but need a tech # to see any of the articles regarding the PM 3000 DNET config. Any help is much appreciated. Regards