jaumet3

Hello, I have a question with l'Instrucion omron PID, with CJ2M. It is possible to get negative values​​? is to get out-but not the way I would like. Get from 0 to -32000 to 32000 and back to 0. I would like to get from -32,000 to 32,000 through 0. Is that possible? the instruction must allow it? Need to achieve this result a proportional valve control that would give the current negative value to a positive side and the other. Greetings and thank you very much

Thanks Geir, I think I have more or less solved the problem. If I have any further questions volvere to post. greetings and thanks

Hello again, I have the PID set the conversions but I can not have any bit of activation? is that in the documentation do not see it and I do not like to waste time on silly as outputs. greetings and thanks

hello and thank you very much Geir, I work out and I have upper and lower margins in the example had not configured. Now I have to use the PID(190) function, I guess I have to set the output and the input that I use but I have a question as what are they known to the automaton which I use, if that uses any other input or output having nothing to do with the pid? Instruction that is best to use the PID (190) or PIDAT (191). Greetings and thank you very much for your help

Hi, I have a problem with the configuration of the module outputs mad42. I can not get them out signal. I understand that by enabling the output of interest (output 0) i the voltages (1v to 5v) and would have to be able to output voltage values​​. For example: Mov #01 d20000 activate output 0 Mov #10 d20001 activate 1v to 5v Mov #XX 2000 output value Whosoever giving a value to 2001 or 2000, I have no clear qual of the two is the output 0, would have to get canbios in the output. But it is not correct. I've seen -0.48 and -0.24 without any control mine. I have to activate something more to function properly? greetings and thanks