jawz
MrPLC Member-
Content count
2 -
Joined
-
Last visited
Posts posted by jawz
-
-
I'm new to all of this so please bear with me, and forgive any ignorance :D We had an Ultra 5000 drive fail on us recently. It powers up fine, but it's in need of repair. We ordered in a replacement and would like to pull the program off the old unit and put it on the new one. Here is what I have encountered ... 1) I can't connect to the old unit (Ultra 5000) using Ultraware. The drive does not show up at all. 2) I've tried to connect to another good working unit (Ultra 5000) and no luck there either. 3) I can connect to the new unit (Ultra 5000 also) using Ultraware. I see the drive show up in Ultraware. The units in 1 & 2 above were not programmed by us. Is there a possibility they are locked out somehow? Do I need to set the communication switch (MSD & LDS) settings to some other setting than what they are using during their auto run? Thanks, Jeff
Pull program from Ultra 5000
in Allen Bradley / Rockwell Automation
Posted