scottl

Thanks Steve forgot to store program used to using windows versa software got it now Thanks again Scott

Hi Steve and Russ I have a ge fanuc 313 cpu 5 slot and can not get the outputs to come on even with a simple one line %I0001 relay f1 fot a q0033 coil f5 the input come on and shows up in the tables and the light comes on for the input but the output does not come on in the table or on the output module. I also tried a %M0001 and that did not show up on the table either. Yes I have it in run mode tried stopping and running again. I set up the cpu onfig for each module I put the catalog numbers in not sure what is going on could you please give me some advice. Or something I can try. Thanks Scott

Hey Steve do you know were I can get a update for versapro from version 1.1 to something newer

Hey Steve or if you could sent a hwcfg file for the 9030 with a 313 and inputs and outputs that would work also

Hey Steve I am using ic690usb901 cable and it is set up as com4 on my pc are you saying I should get a different cable this is the one I was told to get from the person I got the controller from I also got the lm90 software from the same source not sure if the lm90 software is setup right but I have worked on it for about 2 hours and can't seem to get it to communicate Thanks Scott

Hi all I have just bought a 9030 ge fanuc 5 slot plc a 313 and have versa pro software which I have used in the past on a series 90 ge fanuc plc and I also have lm90 software and I have a usb cable set up for com 4 on my pc. I can communicate as far as run and stop on the versa pro ver1.1 software but can not config software for the 9030 hardware and on the lm90 software I can not get it to communicate it alarms with no communication can some please help with this problem Thanks Scott